Home › BRAKE › BRAKE CONTROL › ANTI-LOCK BRAKE SYSTEM

DTC    C1337/37    Different Diameter Tire Malfunction

for Preparation Click here


DESCRIPTION

The skid control ECU measures the speed of each wheel by receiving signals from the speed sensor. These signals are used for recognizing whether all 4 wheels are operating properly. Therefore, all of the wheel signals must be equal.

DTC No.
DTC Detecting Condition
Trouble Areas
C1337/37
At vehicle speed of 18 mph (30 km/h) or more, difference of wheel speeds between front 2 wheels and rear 2 wheels, or front left and right wheels 20 % or more for 60 seconds or more.
  1. Speed sensor
  2. Speed sensor rotor
  3. Speed sensor circuit
  4. Tire size
  5. Brake actuator (skid control ECU)

INSPECTION PROCEDURE

1.CHECK TIRES
  1. Check tire size and condition of all 4 wheels.

    OK:
    All 4 wheels are in same condition.



NG
REPLACE TIRES SO THAT ALL 4 TIRES ARE SAME IN SIZE
OK


2.CHECK SPEED SENSOR ROTOR
  1. Remove the drive shaft, and check around the speed sensor rotor.

    OK:
    No scratches or foreign matter on the sensor tip.



NG
REPLACE SPEED SENSOR ROTOR
OK


3.CHECK SPEED SENSOR


NG
REPLACE SPEED SENSOR
OK


4.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - EACH SPEED SENSOR)


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.RECONFIRM DTC
  1. Clear the DTCs (Click here).

  1. Check if the same DTCs are detected.

    Result
    Proceed to
    DTC output
    A
    DTC not output
    B



B
END
A

REPLACE BRAKE ACTUATOR