Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

DTC    C1256/56    Accumulator Low Pressure

for Preparation Click here


DESCRIPTION

The accumulator pressure sensor is connected to the skid control ECU in the master cylinder solenoid.

C124776E01


DTC No.
DTC Detecting Condition
Trouble Areas
C1256/56
Fluid pressure inside the accumulator drops below the specification value.
  1. Hydraulic brake booster
  2. Hydraulic brake booster pump motor
  3. Hydraulic brake booster pump motor circuit
  4. Accumulator pressure sensor

INSPECTION PROCEDURE

1.RECONFIRM DTC
  1. Clear the DTCs (Click here).

  1. Turn the ignition switch to OFF.

  1. Depress the brake pedal more than 20 times.

  1. Turn the ignition switch to the ON position.

  1. Wait for 99 seconds.

  1. Check if the same DTCs are recorded.

    Result
    Proceed to
    DTC output
    A
    DTC not output
    B



B
END
A


2.CHECK HYDRAULIC CIRCUIT
  1. Perform hydraulic brake booster on-vehicle inspection (Click here).

    OK:
    Hydraulic circuit is normal (No leakage).



NG
CHECK AND REPLACE HYDRAULIC CIRCUIT
OK


3.READ VALUE OF DATA LIST (MASTER CYLINDER PRESSURE SENSOR)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to the ON position.

  1. Turn the intelligent tester ON.

  1. Select the "DATA LIST" mode on the intelligent tester.


Item
Measurement Item / Range (Display)
Normal Condition
Diagnostic Note
ACC PRESS SENS
Accumulator pressure sensor reading / min.: 0 V, max.: 5 V
3.58 to 5 V
If value constant regardless of pump operation, accumulator pressure sensor malfunction suspected.
  1. Check that the accumulator's output value is in the Normal Condition range.

    OK:
    Accumulator pressure sensor value is in the Normal Condition.



NG
REPLACE MASTER CYLINDER SOLENOID
OK


4.RECONFIRM DTC
  1. Clear the DTCs (Click here).

  1. Check if the same DTCs are recorded.

    Result
    Proceed to
    DTC output
    A
    DTC not output
    B



B
END
A

REPLACE MASTER CYLINDER SOLENOID