Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

VEHICLE STABILITY CONTROL SYSTEM > TC and CG Terminal Circuit

for Preparation Click here


DESCRIPTION

Connecting terminals TC and CG of the DLC3 causes the ECU to display 2-digit DTCs by blinking the ABS and VSC TRAC warning lights.

WIRING DIAGRAM


C124788E01


INSPECTION PROCEDURE

1.INSPECT DLC3 (TC TERMINAL VOLTAGE)


    F100115E36
  1. Turn the ignition switch to the ON position.

  1. Measure the voltage.

    Standard:
    Tester Connection
    Specified Condition
    D4-13 (TC) - D4-4 (CG)
    10 to 14 V

  1. Turn the ignition switch to OFF.



NG
Go to step 3
OK


2.CHECK CAN COMMUNICATION SYSTEM
  1. Check whether CAN system DTCs are recorded (Click here).

    Result
    Proceed to
    DTC not output
    A
    DTC output
    B



B
REPAIR CIRCUITS INDICATED BY OUTPUT DTCS
A

REPLACE MASTER CYLINDER SOLENOID 

3.CHECK HARNESS AND CONNECTOR (DLC3 - BODY GROUND)


    F100115E35
  1. Measure the resistance.

    Standard:
    Tester Connection
    Specified Condition
    D4-4 (CG) - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK HARNESS AND CONNECTOR (ECM - DLC3)


    C124791E01
  1. Disconnect the ECM connector.

  1. Measure the resistance.

    Standard (1GR-FE) :
    Tester Connection
    Specified Condition
    D4-13 (TC) - E8-23 (TC)
    Below 1 Ω

    Standard (2TR-FE):
    Tester Connection
    Specified Condition
    D4-13 (TC) - E7-17 (TC)
    Below 1 Ω

  1. Measure the resistance.

    Standard:
    Tester Connection
    Specified Condition
    D4-13 (TC) - Body ground
    10 kΩ or higher

  1. Reconnect the ECM connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.CHECK HARNESS AND CONNECTOR (ECM - SKID CONTROL ECU)


    F052067E01
  1. Disconnect the skid control ECU connector.

  1. Disconnect the ECM connector.

  1. Measure the resistance.

    Standard:
    Tester Connection
    Specified Condition
    S1-25 (CANL) - E7-33 (CANL)
    Below 1 Ω
    S1-11 (CANH) - E7-34 (CANH)
    Below 1 Ω

  1. Reconnect the ECM connector.

  1. Reconnect the skid control ECU connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


6.CHECK ECM (DLC3 (TC) INPUT)


    F100115E36
  1. Connect terminals TC and CG of DLC3.

  1. Turn the ignition switch to the ON position.

  1. Check if the ECM warning light is blinking.

    OK:
    ECM warning light is blinking.

  1. Turn the ignition switch to OFF.

  1. Disconnect the TC and CG terminals of DLC3.



NG
REPLACE ECM
OK

REPLACE MASTER CYLINDER SOLENOID