Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

VEHICLE STABILITY CONTROL SYSTEM > Brake Warning Light does not Come ON

for Preparation Click here


WIRING DIAGRAM

Click here.

INSPECTION PROCEDURE

NOTICE:
When replacing the master cylinder solenoid, perform zero point calibration (Click here).

1.CHECK BRAKE WARNING LIGHT
  1. Disconnect the skid control ECU connector.

  1. Turn the ignition switch to the ON position.

  1. Check that the BRAKE warning light comes on.

    OK:
    BRAKE warning light comes on.

  1. Turn the ignition switch to OFF.

  1. Reconnect the skid control ECU connector.



OK
REPLACE MASTER CYLINDER SOLENOID
NG


2.INSPECT BATTERY
  1. Check the battery voltage.

    Standard:
    11 to 14 V



NG
INSPECT CHARGING SYSTEM
OK


3.INSPECT FUSE (GAUGE)


    F051661E02
  1. Remove the GAUGE fuse from the driver side J/B.

  1. Measure the resistance of the GAUGE fuse.

    Standard:
    Below 1 Ω

  1. Reinstall the GAUGE fuse.



NG
CHECK FOR SHORTS IN ALL HARNESSES AND CONNECTORS CONNECTED TO FUSE AND REPLACE FUSE
OK


4.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - COMBINATION METER)


    F051819E02
  1. Disconnect the skid control ECU connector.

  1. Disconnect the combination meter connector.

  1. Measure the resistance.

    Standard:
    Tester Connection
    Specified Condition
    S2-3 (BRL) - C10-10
    Below 1 Ω

  1. Measure the resistance.

    Standard:
    Tester Connection
    Specified Condition
    S2-3 (BRL) - Body ground
    10 kΩ or higher

  1. Reconnect the combination meter connector.

  1. Reconnect the skid control ECU connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.INSPECT COMBINATION METER ASSEMBLY
  1. Check the combination meter system (Click here).

    OK:
    Combination meter is normal.



NG
REPLACE COMBINATION METER ASSEMBLY
OK

CHECK FOR INTERMITTENT PROBLEMS