DTC C1254/54 Pressure Switch Circuit |

| DTC No. | DTC Detecting Condition | Trouble Areas |
| C1254/54 | Accumulator pressure sensor fault (Fluid pressure does not change when it should e.g. pump operates, brake pedal depressed/released). |
|
| 1.READ VALUE OF DATA LIST (ACCUMULATOR) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to OFF.
Depress the brake pedal more than 20 times.
Turn the ignition switch to the ON position.
Select the DATA LIST mode on the intelligent tester.
| Item | Measurement Item / Range (Display) | Normal Condition | Diagnostic Note |
| ACC PRESS SENS | Accumulator pressure sensor reading / min.: 0 V, max.: 5 V | 3.58 to 5 V | - |
Confirm whether the accumulator output voltage is normal.
| Result | Proceed to |
| Output value normal | A |
| Output value not normal | B |
|
| ||||
| A | |
| 2.READ VALUE OF DATA LIST (MASTER CYLINDER PRESSURE SENSOR) |
Turn the ignition switch to OFF.
Depress the brake pedal more than 20 times.
Install a brake pedal effort gauge (SST), and bleed air.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position.
Select the DATA LIST mode on the intelligent tester.
| Item | Measurement Item / Range (Display) | Normal Condition | Diagnostic Note |
| MAS CYL PRS 1 | Master cylinder pressure sensor 1 reading / min.: 0 V, max.: 5 V | 0.3 to 1.9 V With pedal pressure of 49 N (5 kgf, 11 lbf) | Front brake pressure: 770 to 1280 kpa (7.9 to 13.1 kgf/cm2, 112 to 186 psi) |
Check that the master cylinder output value is in the Normal Condition range.
|
| ||||
| OK | |
| 3.RECONFIRM DTC |
Clear the DTCs (Click here).
Turn the ignition switch to OFF.
Depress the brake pedal more than 20 times.
Turn the ignition switch to the ON position.
Wait until the pump motor stops.
Depress the brake pedal and release it.
Wait for 25 minutes.
Check if the same DTCs are recorded.
| Result | Proceed to |
| DTC output | A |
| DTC not output | B |
|
| ||||
| A | ||
| ||