Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

DTC    C1257/57    IG Power Source

for Preparation Click here


DESCRIPTION

The motor relay (semiconductor relay) is built into the hydraulic brake booster and drives the pump motor based on a signal from the skid control ECU.

DTC No.
DTC Detecting Condition
Trouble Areas
C1257/57
Open in pump motor input circuit
Hydraulic brake booster pump motor circuit

INSPECTION PROCEDURE

1.CHECK HYDRAULIC BRAKE BOOSTER PUMP MOTOR OPERATION
  1. Turn the ignition switch to OFF.

  1. Disconnect the actuator connector (S1).

  1. Depress the brake pedal more than 20 times.

  1. Check the hydraulic brake booster pump motor operation.

    OK:
    Hydraulic brake booster pump operates.



NG
REPLACE MASTER CYLINDER SOLENOID
OK


2.RECONFIRM DTC
  1. Turn the ignition switch to OFF.

  1. Reconnect the actuator connector (S1).

  1. Turn the ignition switch to the ON position.

  1. Clear the DTCs (Click here).

  1. Check if the same DTCs are recorded.

    Result
    Proceed to
    DTC output
    A
    DTC not output
    B



B
END
A

REPLACE MASTER CYLINDER SOLENOID