Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

VEHICLE STABILITY CONTROL SYSTEM > VSC OFF Indicator Light does not Come ON

for Preparation Click here


DESCRIPTION

Click here.

WIRING DIAGRAM

Click here.

INSPECTION PROCEDURE

NOTICE:
When replacing the master cylinder solenoid, perform zero point calibration (Click here).

1.PERFORM ACTIVE TEST BY INTELLIGENT TESTER


    C121700E22
  1. Disconnect the skid control ECU connector.

  1. Turn the ignition switch to the ON position.

  1. Ground terminal WT of the skid control ECU.

  1. Check the VSC OFF indicator light.

    OK:
    IND - GND Condition
    Illumination Condition
    Connecting
    ON
    Disconnecting
    OFF

  1. Turn the ignition switch to OFF.

  1. Reconnect the skid control ECU connector.



OK
REPLACE MASTER CYLINDER SOLENOID
NG


2.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - COMBINATION METER)


    F049577E05
  1. Disconnect the skid control ECU connector.

  1. Disconnect the combination meter connector.

  1. Measure the resistance.

    Standard:
    Tester Connection
    Specified Condition
    S1-35 (WT) - C9-37
    Below 1 Ω
    S1-35 (WT) - Body ground
    10 kΩ or higher

  1. Reconnect the combination meter connector.

  1. Reconnect the skid control ECU connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT COMBINATION METER ASSEMBLY
  1. Check the combination meter system (Click here).

    OK:
    Combination meter is normal.



NG
REPLACE COMBINATION METER ASSEMBLY
OK

CHECK FOR INTERMITTENT PROBLEMS