Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING SYSTEM

TIRE PRESSURE WARNING SYSTEM > TC and CG Terminal Circuit

for Preparation Click here


DESCRIPTION

DTC output mode is set by connecting terminals TC and CG of the DLC3. The stored DTCs are indicated by the blinking patterns of the tire pressure warning light.

WIRING DIAGRAM

HINT:
When all the warning lights continue blinking, a ground short in the wiring of terminal TC of the DLC3 is suspected.


C122908E01


INSPECTION PROCEDURE

NOTICE:
  1. When replacing the tire pressure warning ECU, read the IDs stored in the ECU using the intelligent tester and note them down before removal (Click here ).
  2. It is necessary to perform initialization (Click here) after registration (Click here ) the transmitter IDs into the tire pressure warning ECU after the tire pressure warning ECU and/or tire pressure warning valve and transmitter have been replaced.

1.CHECK HARNESS AND CONNECTOR (DLC3 - TIRE PRESSURE WARNING ECU)


    C124995E01
  1. Disconnect the connector from the tire pressure warning ECU.

  1. Measure the resistance.

    Standard resistence:
    Tester Connection
    Specified Condition
    TC (T14-12) - TC (D4-13)
    Below 1 Ω

  1. Reconnect the connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK HARNESS AND CONNECTOR (DLC3 - BODY GROUND)


    F100115E33
  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Specified Condition
    CG (D4-4) - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK HARNESS AND CONNECTOR (TIRE PRESSURE WARNING ECU - BODY GROUND)


    C122898E08
  1. Disconnect the connector from the tire pressure warning ECU.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Specified Condition
    TC (T14-12) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR AND EACH ECU
OK

REPLACE TIRE PRESSURE WARNING ECU