Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING SYSTEM

DTC    C2191/91    Vehicle Speed Signal Error (Test Mode DTC)

for Preparation Click here


DESCRIPTION

The tire pressure warning ECU receives a speed signal from the combination meter. This DTC is stored upon entering test mode, and cleared when a vehicle speed signal of 12 mph (20 km/h) is detected for 3 seconds or more. The DTC is output only during test mode.

DTC No.
DTC Detection Condition
Trouble Area
C2191/91
Speed sensor signal circuit malfunction.
  1. Combination meter
  2. Vehicle speed sensor
  3. Tire pressure warning ECU
  4. Wire harness or connector

WIRING DIAGRAM


C122905E01


INSPECTION PROCEDURE

NOTICE:
  1. When replacing the tire pressure warning ECU, read the IDs stored in the ECU using the intelligent tester and note them down before removal (Click here ).
  2. It is necessary to perform initialization (Click here) after registration (Click here ) the transmitter IDs into the tire pressure warning ECU after the tire pressure warning ECU and/or tire pressure warning valve and transmitter have been replaced.

HINT:
Start the inspection from step 1 when using the intelligent tester, and start from step 2 when not using the intelligent tester.

1.READ VALUE OF INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to the ON position, and turn the intelligent tester on.

  1. Select the item shown in the table below from the DATA LIST, and read the value displayed on the intelligent tester.

    HINT:
    Enter the following menus: Chassis/TPWS/DATA LIST


    VEHICLE SPEED:

    Item
    Normal Condition
    VEHICLE SPEED
    Actual vehicle speed

  1. Check that the values indicated on the tester and on the combination meter are the same.

    OK:
    Vehicle speed displayed on the intelligent tester indicates the actual vehicle speed.



OK
REPLACE TIRE PRESSURE WARNING ECU
NG


2.CHECK HARNESS AND CONNECTOR (TIRE PRESSURE WARNING ECU - COMBINATION METER)


    C124992E01
  1. Disconnect the connectors from the combination meter and tire pressure warning ECU.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Specified Condition
    SPD (T14-3) - SPD (C9-19)
    Below 1 Ω
    SPD (T14-3) - Body ground
    10 kΩ or higher
    GND (T14-11) - Body ground
    Below 1 Ω

Reconnect the connectors.


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT TIRE PRESSURE WARNING ECU


    C124993E02
  1. Disconnect the connector from the tire pressure warning ECU.

  1. Check the voltage

    1. Move the shift lever to the neutral position.

    2. Jack up one of the rear wheels.

    3. Turn the ignition switch to the ON position.

    4. Measure the voltage between terminals SPD and GND of the tire pressure warning ECU as the rear tire is turned slowly.

      OK:
      Voltage is generated intermittently.

      HINT:
      As the vehicle speed (wheel revolution speed) increases, the cycle of the fluctuation in the waveform becomes faster.



NG
CHECK COMBINATION METER (SPEED SIGNAL CIRCUIT)
OK

REPLACE TIRE PRESSURE WARNING ECU