Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING SYSTEM

TIRE PRESSURE WARNING SYSTEM > Tire Pressure Warning Reset Switch Circuit

for Preparation Click here


DESCRIPTION

Tire pressure warning reset switch is adopted for initialization of the tire pressure warning threshold.
When the tire pressure warning reset switch is pressed for 3 seconds or more, the tire pressure data is registered in the tire pressure warning ECU.
The tire pressure warning reset switch condition is checked through the DATA MONITOR using the intelligent tester or by conducting the TEST MODE PROCEDURE.

WIRING DIAGRAM


C122906E01


INSPECTION PROCEDURE

NOTICE:
  1. When replacing the tire pressure warning ECU, read the IDs stored in the ECU using the intelligent tester and note them down before removal (Click here ).
  2. It is necessary to perform initialization (Click here) after registration (Click here ) the transmitter IDs into the tire pressure warning ECU after the ECU have been replaced.

1.READ VALUE OF DATA LIST (INITIAL SW)
  1. Connect the intelligent tester to the DLC3 connector.

  1. Turn the ignition switch to the ON position and turn the tester ON.

  1. Select INITIAL SW by following the prompts displayed on the intelligent tester.

    Standard:

    Item
    Condition
    Specified Condition
    INITIAL SW
    Tire pressure warning reset switch
    OFF → ON
    Display
    OFF → ON



NG
Go to step 2
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE 

2.INSPECT TIRE PRESSURE WARNING RESET SWITCH


    C107260E02
  1. Disconnect the connector from the tire pressure warning reset switch.

  1. Measure the resistance between terminals 1 and 2 of the tire pressure warning reset switch.

    Standard resistance:
    Switch Condition
    Specified Condition
    ON
    Below 1 Ω
    OFF
    10 kΩ or higher



NG
REPLACE TIRE PRESSURE WARNING RESET SWITCH
OK


3.CHECK HARNESS AND CONNECTOR (TIRE PRESSURE WARNING RESET SWITCH-TIRE PRESSURE WARNING ECU)


    C124994E01
  1. Disconnect the connector from the tire pressure warning ECU.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Specified Condition
    CALSW (T14-10) - T15-1
    Below 1 Ω
    CALSW (T14-10) - Body ground
    10 kΩ or higher
    T15-2 - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE