Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING SYSTEM

DTC    C2171/71    Transmitter ID not Registered

for Preparation Click here


DESCRIPTION

The IDs of each tire pressure warning valve and transmitters are registered to the tire pressure warning ECU.
When the ECU detects that an ID is not the one of registered IDs, or cannot receive an ID signal, a DTC is output.

INSPECTION PROCEDURE

NOTICE:
  1. When replacing the tire pressure warning ECU, read the IDs stored in the ECU using the intelligent tester and note them down before removal (Click here ).
  2. It is necessary to perform initialization (Click here) after registration (Click here ) the transmitter IDs into the tire pressure warning ECU after the tire pressure warning ECU and/or tire pressure warning valve and transmitter have been replaced.

1.CONFIRM REGISTRATION CONDITION (REGISTERED ID CODES)
  1. Connect the intelligent tester to the DLC3 connector.

  1. Turn the ignition switch to the ON position and turn the tester ON.

  1. Select REGIT ID CODE by following the prompts displayed on the intelligent tester.

    OK:
    The registered transmitter ID codes are displayed on the intelligent tester screen.



OK
REPLACE TIRE PRESSURE WARNING ECU
NG


2.PERFORM REGISTRATION (TRANSMITTER ID)
  1. Register the transmitter IDs for all the wheels (Click here ).

  1. Set the tire pressures of all the wheels to the appropriate specified values.


NEXT


3.READ VALUE OF DATA LIST
  1. Check the DATA LIST (Click here ).

  1. Select TIREPRESS by following the prompts displayed on the intelligent tester.

    HINT:
    It may take up to 1 minute to display the tire pressure data.


    Result :

    Condition
    Proceed to
    All tire pressure readings are equal to specified values.
    A
    Tire pressure values not display.
    B



B
REPLACE TIRE PRESSURE WARNING ECU
A

END