Home › ENGINE ยท 1GR-FE › ENGINE CONTROL SYSTEM › SFI SYSTEM

SFI SYSTEM > CHECK FOR INTERMITTENT PROBLEMS

for Preparation Click here


HINT:
Inspect the vehicle's ECM using check mode. Intermittent problems are easier to detect with the Techstream when the ECM is in check mode. In check mode, the ECM uses 1 trip detection logic, which is more sensitive to malfunctions than normal mode (default), which uses 2 trip detection logic.

  1. Clear DTCs (Click here).
  2. Switch the ECM from normal mode to check mode using the Techstream (Click here).
  3. Perform a simulation test (Click here).
  4. Check and wiggle the harness(es), connector(s) and terminal(s) (Click here).