Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
Use these procedures to troubleshoot the audio and visual system.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE
    1. Inspect the battery voltage.

      Standard Voltage:
      11 to 14 V

      1. If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.


    NEXT


    3.BASIC INSPECTION
    1. Turn the ignition switch to ON.

    2. Check whether or not the radio receiver assembly turns on.
      Result 
      Result
      Proceed to
      Radio receiver assembly turns on
      A
      Radio receiver assembly does not turn on
      B



    B.
    Go to step 6
    A


    4.CHECK FOR DTC
    1. Check for DTCs and note any codes that are output.

    2. Delete the DTCs.

    3. Recheck for DTCs by simulating the operation indicated by the DTCs.

      HINT:
      1. If the system cannot enter the diagnostic mode, inspect the AVC-LAN and all the components that connect to the AVC-LAN for short circuits and repair or replace the problem part.
      2. Even if the malfunction symptom is not confirmed, check the DTCs. This is because the system stores past DTCs.
      3. Check and clear past DTCs. Then check for DTCs.

      Result 
      Result
      Proceed to
      DTC is output again
      A
      DTC is not output
      B



    B.
    Go to step 6
    A


    5.DIAGNOSTIC TROUBLE CODE CHART
    1. Refer to Diagnostic Trouble Code Chart (Click here).


    NEXT

    Go to step 8


    6.PROBLEM SYMPTOMS TABLE
    1. Refer to Problem Symptoms Table (Click here).
      Result 
      Result
      Proceed to
      Fault is not listed in Problem Symptoms Table
      A
      Fault is listed in Problem Symptoms Table
      B



    B.
    Go to step 8
    A


    7.PERFORM TROUBLESHOOTING BASED ON MALFUNCTION SYMPTOM
    1. Refer to Terminals of ECU (Click here).


    NEXT


    8.ADJUST, REPAIR OR REPLACE

      NEXT


      9.CONFIRMATION TEST

        NEXT

        END