Home › ENGINE · 1GR-FE › ENGINE CONTROL SYSTEM › SFI SYSTEM

DTC    P0230    Fuel Pump Primary Circuit

for Preparation Click here


DESCRIPTION

As shown in the illustration, when the engine is cranked, current flows from terminal ST1 of the ignition switch into the ECM and the STA relay (starter relay) coil and also current flows to terminal STA of the ECM (STA signal).
When the STA signal and NE signal are input to the ECM, Tr1 (power transistor 1) is turned ON, current flows to the coil of the circuit opening relay, the relay switches on, power is supplied to the fuel pump, and the fuel pump operates.
While the NE signal is generated (engine running), the ECM keeps the Tr1 ON (circuit opening relay ON) and the fuel pump also keeps operating.
The fuel pump speed is controlled at two levels (high speed or low speed) by engine condition (starting, light load, heavy load). When the engine starts (STA ON), Tr2 (power transistor 2) in the ECM is OFF, so the fuel pump relay closes and positive battery voltage is applied directly to the fuel pump. The fuel pump operates at high speed.
During idling or under light loads, Tr2 goes ON, and then power is supplied to the fuel pump via the fuel pump resistor. The fuel pump operates at low speed.

A218141E03


DTC No
DTC Detection Condition
Trouble Area
P0230
Open or short in fuel pump relay circuit
(1 trip detection logic)
  1. Open or short in fuel pump relay circuit
  2. Fuel pump relay
  3. ECM

WIRING DIAGRAM


A193262E04

HINT:
This DTC chart is on the premise that the engine is started normally. If the engine is difficult to start, proceed to the problem symptoms table (Click here).


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

HINT:
Read freeze frame data using the Techstream. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air fuel ratio was lean or rich, and other data from the time the malfunction occurred.

1.INSPECT ECM (FPR VOLTAGE)
A193171E33
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    E14-8 (FPR) - E11-12 (E1)
    Cranking
    11 to 14 V
    E14-8 (FPR) - E11-12 (E1)
    Ignition switch ON
    0 to 3 V

    Text in Illustration 
    *a
    Component with harness connected
    (ECM)



NG
REPLACE ECM (Click here)
OK


2.INSPECT FUEL PUMP RELAY
  1. Inspect the fuel pump relay (Click here).



NG
REPLACE FUEL PUMP RELAY
OK


3.CHECK HARNESS AND CONNECTOR (FUEL PUMP RELAY - ECM)
  1. Remove the fuel pump relay from the engine room relay block.

  1. Disconnect the ECM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:

    Tester Connection
    Condition
    Specified Condition
    1 (Fuel pump relay holder) - E14-8 (FPR)
    Always
    Below 1 Ω
    1 (Fuel pump relay holder) or E14-8 (FPR) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE ECM (Click here)