DTC P0128 Coolant Thermostat (Coolant Temperature Below Thermostat Regulating Temperature) |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0128 | Conditions (a), (b) and (c) are met for 5 seconds (2 trip detection logic)
|
|

| Related DTCs | P0128: Coolant Thermostat |
| Required Sensors/Components (Main) | Engine coolant temperature Thermostat |
| Required Sensors/Components (Related) | Intake air temperature sensor Vehicle speed sensor |
| Frequency of Operation | Once per driving cycle |
| Duration | 900 seconds |
| MIL Operation | 2 driving cycles |
| Sequence of Operation | None |
| Monitor runs whenever following DTCs not stored | P0010, P0020 (Camshaft timing oil control valve) P0011, P0021 (VVT system - advance) P0012, P0022 (VVT System - retard) P0016, P0018 (VVT system - misalignment) P0031, P0032, P0051, P0052, P101D, P103D (Air fuel ratio sensor heater) P0102, P0103 (Mass air flow meter) P0112, P0113 (Intake air temperature sensor) P0115, P0117, P0118 (Engine coolant temperature sensor) P0120, P0121, P0122, P0123, P0220, P0222, P0223, P2135 (Throttle position sensor) P014C, P014D, P014E, P014F, P015A, P015B, P015C, P015D, P2195, P2196, P2197, P2198, P2237, P2238, P2239, P2240, P2241, P2242, P2252, P2253, P2255, P2256 (Air fuel ratio sensor) P0171, P0172, P0174, P0175 (Fuel system) P0301, P0302, P0303, P0304, P0305, P0306 (Misfire) P0335 (Crankshaft position sensor) P0340, P0342, P0343, P0345, P0347, P0348 (VVT sensor) P0351, P0352, P0353, P0354, P0355, P0356 (Igniter) P0500 (Vehicle speed sensor) P219A, P219B (Air-fuel ratio imbalance) |
| Battery voltage | 11 V or more |
| Either of following conditions 1 or 2 met: | - |
| 1. All of following conditions (a), (b) and (c) met: | - |
| (a) Engine coolant temperature at engine start - Intake air temperature at engine start | -15 to 7°C (-27 to 12.6°F) |
| (b) Engine coolant temperature at engine start | -10 to 56°C (14 to 133°F) |
| (c) Intake air temperature at engine start | -10 to 56°C (14 to 133°F) |
| 2. All of following conditions (d), (e) and (f) met: | - |
| (d) Engine coolant temperature at engine start - Intake air temperature at engine start | More than 7°C (45°F) |
| (e) Engine coolant temperature at engine start | 56°C (133°F) or less |
| (f) Intake air temperature at engine start | -10°C (14°F) or more |
| Accumulated time with 128 km/h (80 mph) or more of vehicle speed | Less than 20 seconds |
| Duration that following conditions A and B met | 5 seconds or more |
| A. Estimated engine coolant temperature | 75°C (167°F) or more |
| B. Engine coolant temperature sensor output | Less than 75°C (167°F) |

| 1.CHECK ANY OTHER DTC OUTPUT (IN ADDITION TO DTC P0128) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menu: Powertrain / Engine and ECT / Trouble Codes.
Read DTC.
| Result | Proceed to |
| DTC P0128 is output | A |
| DTC P0128 and other DTCs are output | B |
|
| ||||
| A | |
| 2.CHECK COOLING SYSTEM |
Check for defects in the cooling system that might cause the system to be too cold, such as abnormal radiator fan operation or any modifications.
|
| ||||
| OK | |
| 3.INSPECT WATER INLET WITH THERMOSTAT |
Check the valve opening temperature of the water inlet with thermostat (Click here).
|
| ||||
| OK | ||
| ||