Home › ENGINE · 1GR-FE › FUEL › FUEL INJECTOR

FUEL INJECTOR > INSPECTION

for Preparation Click here



1. INSPECT FUEL INJECTOR ASSEMBLY


    A095332E03
  1. Check the resistance.

    1. Using an ohmmeter, measure the resistance between the terminals.

      Standard:
      Tester Connection
      Specified Condition
      1 -2
      11.6 to 12.4 Ωat 20°C (68°F)

      If the result is not as specified, replace the fuel injector.



    A075912E01
  1. Check the injection volume.

    NOTICE:
    1. Perform the test in a well-ventilated area and watch out for flames.
    2. Handle the fuel tube connector carefully.




      B012947E10
    1. Install the SST (fuel tube connector) into SST (hose), then connect the tube connector to the fuel pipe.

      SST
      09268-31012   (95336-08070, 09268-41091)
      09268-41140  
      09268-41400   (09268-41500)
      09842-30080  

    2. Remove the pressure regulator (Click here).

    3. Install the O-ring onto the fuel inlet of the pressure regulator.



    4. A076630E01
    5. Connect SST (hose) to the fuel inlet of the pressure regulator with another SST (union) and the 2 bolts.

      SST
      09268-31012   (95336-08070, 09268-41091)

      Torque:
      9.0 N*m{ 92 kgf*cm , 80 in.*lbf }

    6. Connect the fuel return hose to the fuel outlet of the pressure regulator.



    7. A075914E03
    8. Install a new O-ring onto the injector.

    9. Connect SST (adaptor and hose) to the injector and hold the injector and union with SST (clamp).

      SST
      09268-31012   (95336-08070)
      09268-41140  
      09268-41400  

    10. Set the injector in a graduated cylinder.

      CAUTION:
      Install a suitable vinyl tube onto the injector to prevent gasoline splashes.

    11. Connect the Techstream to the DLC3.

    12. Turn the ignition switch to ON.

    13. Turn the Techstream ON.

    14. Enter the following menu:
      Select: Data List / Powertrain / Engine and ECT / Active Test / Control the Fuel Pump / Speed.

    15. Install SST onto the fuel injector.

      SST
      09842-30080  



    16. A075915E06
    17. Connect SST to the battery, then measure the injection volume for 15 seconds. Perform the inspection 2 or 3 times, then calculate the average.

      Standard::
      Injection Volume
      Difference Between Each Fuel Injector
      76 to 91 cm3 (4.6 to 5.5 cu in.) per 15 seconds
      15 cm3 (0.9 cu in.) or less

      NOTICE:
      Always do the switching at the battery side.

      If the result is not as specified, replace the fuel injector.

  1. Check the fuel leakage.

    1. When checking the injection volume, remove SST from the battery. Inspect the fuel leakage from the fuel injector.

      Standard:
      1 drop or less every 12 minutes.

      If the result is not as specified, replace the fuel injector.