Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM (for Vacuum Brake Booster)

DTC    C1281    Master Cylinder Pressure Sensor Output Malfunction (Test Mode DTC)

DTC    C1421    Open or Short in Master Cylinder Pressure Sensor

DTC    C1423    Master Cylinder Pressure Sensor Zero Point Low Malfunction

DTC    C1424    Master Cylinder Pressure Sensor Output Malfunction

for Preparation Click here


DESCRIPTION


C230327E02


DTC Code
DTC Detection Condition
Trouble Area
C1281
Stored only during test mode.
  1. Master cylinder pressure sensor circuit
  2. Skid control ECU, master cylinder pressure sensor (brake actuator assembly)
C1421
Either condition is met:
Both of the following conditions continue for at least 1.2 seconds.
  1. The IG1 terminal voltage is between 9.5 V and 17.0 V.
  2. The VM/C1 terminal voltage is not within 4.4 V and 5.6 V.
Both of the following conditions continue for at least 1.2 seconds.
  1. The VM/C1 terminal voltage is between 4.4 V and 5.6 V.
  2. The PM/C1 terminal voltage is not within 0.19 V and 4.57 V.
C1423
Both of the following conditions continue for at least 5 seconds
  1. The stop light switch is off.
  1. The PM/C1 terminal voltage is below 0.27 V.
C1424
One of the following conditions is met:
  1. Noise occurs in the signal from the PM/C1 terminal 7 times or more within 5 seconds
  2. When the vehicle speed drops from 40 km/h (25 mph) to 10 km/h (6 mph), the master cylinder pressure does not change by at least 0.048 MPa.
  3. At a vehicle speed of 7 km/h (4 mph) or more, the PM/C1 terminal voltage is between 0.86 and 1.0 V and master cylinder pressure does not change by at least 0.048 MPa for 60 seconds or more.
  4. At a vehicle speed of 7 km/h (4 mph) or more, the PM/C1 terminal voltage is 1.0 V or higher and master cylinder pressure does not change by at least 0.048 MPa for 30 seconds or more.
  5. At a vehicle speed of 7 km/h (4 mph) or more with the stop light switch ON, a state in which the master cylinder pressure sensor input value is sufficiently greater than the estimated master pressure continues for 1 second or more and this state occurs 5 or more times each time the ignition switch is turned to ON, and this occurs 8 or more times consecutively.

INSPECTION PROCEDURE

NOTICE:
When replacing the brake actuator assembly, perform calibration (Click here).

1.REPLACE BRAKE ACTUATOR ASSEMBLY
  1. Replace the brake actuator assembly (Click here).


NEXT

END