DTC P0418 Secondary Air Injection System Control "A" Circuit |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0418 | All conditions are met for 3 seconds or more while idling immediately after the engine is started (2 trip detection logic):
|
|
| P0418 | All conditions are met for 3 seconds or more while idling immediately after the engine is started (2 trip detection logic):
|
|
| Related DTCs | P0418: Secondary air injection system air pump circuit range check (Bank 1) |
| Required Sensors/Components (Main) | Air injection control driver |
| Required Sensors/Components (Related) | Air pump assembly |
| Frequency of Operation | Once per drive cycle |
| Duration | 3 seconds |
| MIL Operation | 2 driving cycles |
| Sequence of Operation | None |
| Monitor runs whenever following DTCs not stored | None |
| All of the following conditions are met | - |
| Air pump | Operating |
| Air switching valve | Operating |
| Battery voltage | 8 V or higher |
| Ignition switch | ON |
| Starter | OFF |
| All of the following conditions are met | - |
| Air pump | Not operating |
| Air switching valve | Not operating |
| Battery voltage | 8 V or higher |
| Ignition switch | ON |
| Starter | OFF |
| Diagnostic signal duty ratio from air injection control driver | 11% or more, and 29% or less |
| Diagnostic signal duty ratio from air injection control driver | 70% or more, and 90% or less when secondary air injection system operating. 0% when secondary air injection system not operating. |
| Techstream Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|
| 1.CHECK HARNESS AND CONNECTOR (AIR PUMP ASSEMBLY - AIR INJECTION CONTROL DRIVER, BODY GROUND) |
Disconnect the cable from the negative (-) battery terminal.
Disconnect the cable from the positive (+) battery terminal.
Disconnect the air pump assembly connector.
Disconnect the air injection control driver connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A30-2 (+B) - A6-2 (VP) | Always | Below 1 Ω |
| A30-4 - Body ground | Always | Below 1 Ω |
| A6-1 (BATT) - Positive (+) battery cable | Always | Below 1 Ω |
| A30-2 (+B) or A6-2 (VP) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 2.INSPECT AIR PUMP ASSEMBLY |
Inspect the air pump assembly (Click here).
|
| ||||
| OK | ||
| ||
| 3.REPLACE AIR PUMP ASSEMBLY |
Replace the air pump assembly (Click here).
| NEXT | |
| 4.CHECK WHETHER DTC OUTPUT RECURS (DTC P0418) |
Start the engine and warm it up.
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON and turn the Techstream on.
Clear DTCs (if stored) (Click here).
Enter the following menus: Powertrain / Engine and ECT / Utility / Secondary Air injection check / Automatic Mode.
Start the engine after the Techstream initialization is finished.
Perform the System Check operation by pressing Next.
After operating the secondary air injection system, perform the following to confirm the secondary air injection system pending DTCs: Press the Exit.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read the pending DTCs.
Turn the ignition switch off.
|
| ||||
| OK | ||
| ||