DTC P0722 Output Speed Sensor Circuit No Signal |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0722 | Both conditions are met for 5 seconds or more continuously (2 trip detection logic) (a) No signal from speed sensor SP2 is input to the ECM. (b) Vehicle speed is 9 km/h (5.59 mph) or more. |
|

| Terminal | SP2+- SP2- |
| Tool setting | 2 V/DIV, 20 ms/DIV |
| Vehicle condition | Vehicle speed 20 km/h (12 mph) |
| Related DTCs | P0722: Speed sensor SP2/Verify pulse input |
| Required sensors/Components | Speed sensor SP2 |
| Frequency of operation | Continuous |
| Duration | 5 seconds |
| MIL operation | 2 driving cycles |
| Sequence of operation | None |
| Monitor runs whenever following DTCs not present. | None |
| Battery voltage | 8 V or more |
| Ignition switch | ON |
| Starter | OFF |
| Vehicle speed from vehicle speed sensor | 9 km/h (5.59 mph) or more |
| Speed sensor signal | No signal |
| Vehicle speed from output speed sensor | 9 km/h (5.59 mph) or more |

| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| SPD (SP2) | Output shaft speed/ Min.: 0 km/h (0 mph) Max.: 255 km/h (158 mph) | 0 km/h (0 mph) (output shaft speed equal to vehicle speed): Vehicle stopped | - |
| 1.INSPECT SPEED SENSOR (SP2) INSTALLATION |
![]() |
Check the speed sensor (SP2) installation.
| *a | Correct |
| *b | Incorrect |
|
| ||||
| OK | |
| 2.INSPECT SPEED SENSOR (SP2) |
![]() |
Disconnect the speed sensor (SP2) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | 20°C (68°F) | 560 to 680 Ω |
| *a | Component without harness connected (Speed Sensor (SP2)) |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (SPEED SENSOR (SP2) - ECM) |
![]() |
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E5-35 (SP2+) - E5-27 (SP2-) | 20°C (68°F) | 560 to 680 Ω |
| E5-35 (SP2+) - Body ground | Always | 10 kΩ or higher |
| E5-27 (SP2-) - Body ground | Always | 10 kΩ or higher |
| *a | Rear view of wire harness connector (to ECM) |
|
| ||||
| OK | ||
| ||