Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › REAR VIEW MONITOR SYSTEM (w/ Navigation System)

REAR VIEW MONITOR SYSTEM (w/ Navigation System) > HOW TO PROCEED WITH TROUBLESHOOTING


HINT:
Use the following procedure to troubleshoot the rear view monitor system.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE
    1. Measure the battery voltage.

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, replace or recharge the battery before proceeding to the next step.


    NEXT


    3.CHECK AND CLEAR DTCs
    1. Refer to DTC Check/Clear of the navigation system (Click here).


    NEXT


    4.PROBLEM SYMPTOM CONFIRMATION
      Result 
      Result
      Proceed to
      Symptom does not occur
      A
      Symptom occurs
      B


    B.
    Go to step 6
    A


    5.SYMPTOM SIMULATION

      NEXT


      6.CHECK IF SAME SYMPTOM APPEARS IN NAVIGATION SYSTEM
      1. Refer to the navigation system (Click here).
        Result 
        Result
        Proceed to
        Symptom does not appear
        A
        Symptom appears
        B



      B.
      GO TO NAVIGATION SYSTEM (Click here)
      A


      7.PROBLEM SYMPTOMS TABLE
      1. Refer to Problem Symptoms Table (Click here).
        Result 
        Result
        Proceed to
        Fault is not listed in Problem Symptoms Table
        A
        Fault is listed in Problem Symptoms Table
        B



      B.
      Go to step 9
      A


      8.PERFORM TROUBLESHOOTING BASED ON MALFUNCTION SYMPTOM
      1. Terminals of ECU (Click here)


      NEXT


      9.ADJUST, REPAIR OR REPLACE

        NEXT


        10.CONFIRMATION TEST

          NEXT

          END