NAVIGATION SYSTEM > Mute Signal Circuit between Radio Receiver and Extension Module |

| 1.INSPECT EXTENSION MODULE |
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E15-1 (MUTE) - Body ground | Ignition switch ACC, audio system is playing → Changing modes | Above 3.5 V → Below 1 V |
| *a | Component with harness connected (Extension Module) |
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - EXTENSION MODULE) |
Disconnect the R20 radio and display receiver assembly connector.
Disconnect the E15 extension module connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| R20-6 (MUTE) - E15-1 (MUTE) | Always | Below 1 Ω |
| R20-6 (MUTE) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.INSPECT RADIO AND DISPLAY RECEIVER ASSEMBLY (OUTPUT SIGNAL) |
Reconnect the radio and display receiver assembly connector.
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E15-1 (MUTE) - Body ground | Ignition switch ACC, audio system is playing | Above 3.5 V |
| *a | Front view of wire harness connector (to Extension Module) |
|
| ||||
| OK | ||
| ||