ENGINE IMMOBILISER SYSTEM > ECU Power Source Circuit |

| 1.INSPECT FUSES (ECU-B AND IGN) |
Remove the ECU-B fuse from the engine room R/B and J/B.
Remove the IGN fuse from the driver side J/B.
Measure the resistance of the fuse.
Reinstall fuses.
|
| ||||
| OK | |
| 2.INSPECT IGNITION SWITCH ASSEMBLY |
![]() |
Remove the ignition switch.
Measure the resistance of the switch.
| Tester Connection | Switch Condition | Specified Condition |
| 5 (AM2) - 6 (IG2) | LOCK, ACC | 10 kΩ or higher |
| ON, START | Below 1 Ω |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU ASSEMBLY - BATTERY AND BODY GROUND) |
![]() |
Disconnect the T10 ECU connector.
Measure the resistance and voltage of the wire harness side connector.
| Tester Connection | Condition | Specified Condition |
| T10-16 (GND) - Body ground | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| T10-1 (+B) - Body ground | Always | 10 to 14 V |
| T10-2 (IG) - Body ground | Ignition switch OFF | Below 1 V |
| Ignition switch ON | 10 to 14 V |
Reconnect the ECU connector.
|
| ||||
| OK | ||
| ||