Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM

DTC    B2780    Push Switch / Key Unlock Warning Switch Malfunction

for Preparation Click here


DESCRIPTION

This DTC will be output if the transponder key ECU does not detect that the unlock warning switch is ON even when the key is inserted into the ignition key cylinder. Under normal conditions, the unlock warning switch is ON when the key is inserted into the ignition key cylinder.

DTC No.
DTC Detection Condition
Trouble Areas
B2780
Unlock warning switch ON is not detected when when the key is inserted into the ignition key cylinder
  1. Wire harness and connector
  2. Transponder key amplifier
  3. Transponder key ECU assembly

WIRING DIAGRAM


B121681E02


INSPECTION PROCEDURE

1.READ VALUE USING TECHSTREAM (UNLOCK WARNING SWITCH)
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch ON with the key that cannot start the engine.

  1. On the Techstream, enter the following menus: Body Electrical / Immobiliser / Data List / Key SW. Read the values.


Immobiliser 
Item
Measurement Item/ ON or OFF
Normal Condition
Diagnostic Note
Key SW
Unlock warning switch signal / ON or OFF
OFF: No key is in ignition key cylinder
ON: Key is in ignition key cylinder
-

OK:
"ON" (key is in ignition key cylinder) appears on the screen.



OK
REPLACE TRANSPONDER KEY ECU ASSEMBLY (Click here)
NG


2.INSPECT UNLOCK WARNING SWITCH ASSEMBLY


    B087948E01
  1. Remove the unlock warning switch.

  1. Measure the resistance of the switch.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1-2
    Pushed
    Below 1Ω
    1-2
    Not pushed
    10 kΩ or higher

  1. Reinstall the unlock warning switch.



NG
REPLACE UNLOCK WARNING SWITCH ASSEMBLY
OK


3.CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - UNLOCK WARNING SWITCH)


    B087949E02
  1. Disconnect the T10 ECU connector.

  1. Disconnect the U1 switch connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    T10-3 (KSW) - U1-1
    Below 1 Ω
    U1-2 - Body ground
    Below 1 Ω

  1. Reconnect the unlock warning switch connector.

  1. Reconnect the ECU connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE TRANSPONDER KEY ECU ASSEMBLY (Click here)