FRONT SEAT OUTER BELT ASSEMBLY (for Regular Cab) > DISPOSAL |
![]() |
| 1. DISPOSE OF FRONT SEAT OUTER BELT ASSEMBLY (When Installed in Vehicle) |
![]() |
![]() |
Check whether SST is functioning.
Connect SST red clip to the battery positive (+) terminal and the black clip to the battery negative (-) terminal.
![]() |
Press SST activation switch and check that the LED of SST activation switch turns on.
Disconnect SST from the battery.
Disconnect the pretensioner connector.
Disconnect cable from negative battery terminal.
Remove the front door scuff plate .
Remove the front door opening trim weatherstrip .
Remove the back panel trim cover .
Remove the back panel upper garnish .
Remove the jack (for Separate Seat Type).
Remove the back panel trim cover (for Separate Seat Type) .
Remove the back panel trim (for Separate Seat Type) .
Remove the quarter trim lower panel .
![]() |
Install the floor anchor with the bolt.
Disconnect the pretensioner connector as shown in the illustration.
![]() |
Connect the SST.
Connect SST, then connect the yellow connector to the seat belt pretensioner.
![]() |
Move SST at least 10 m (33 ft) away from the front of the vehicle.
Close all the doors and windows of the vehicle.
Connect SST red clip to the battery positive (+) terminal and the black clip to the battery negative (-) terminal.
Activate the seat belt pretensioner.
Confirm that no one is inside the vehicle or within 10 m (33 ft) of the vehicle.
Press SST activation switch and activate the seat belt pretensioner.
Dispose of the outer belt (with the seat belt pretensioner).
| 2. DISPOSE OF FRONT SEAT OUTER BELT ASSEMBLY (When not Installed in Vehicle) |
Remove the front seat outer belt (Click here).
![]() |
Wind the seat belt with the retractor.
When the seat belt is sufficiently wound, cut the seat belt approximately 10 cm (0.328 ft) from the retractor, as shown in the illustration.
Check whether SST is functioning (see step 2-(a)).
![]() |
Connect SST.
Connect SST, then connect them to the seat belt pretensioner.
![]() |
Place the outer belt on the ground and cover it with a tire with a wheel attached.
![]() |
Move SST at least 10 m (33 ft) away from the wheel.
Activate the seat belt pretensioner.
Connect SST red clip to the battery positive (+) terminal and the black clip to the battery negative (-) terminal.
Check that no one is within 10 m (33 ft) of the wheel.
Press SST activation switch and activate the seat belt pretensioner.
![]() |
Dispose of the outer belt (with the seat belt pretensioner).
Remove the wheel and SST.
Place the outer belt in a plastic bag, tie the end tightly and dispose of it in the same way as other general parts.