PRESSURE SWITCH > ON-VEHICLE INSPECTION |
| 1. INSPECT PRESSURE NO. 1 SWITCH |
![]() |
Inspect refrigerant pressure in the air conditioning cycle.
Read the manifold gauge pressure when the conditions below are established. (*2)
Test conditions:
![]() |
Check the air conditioning operation.
Disconnect the pressure switch connector.
Connect terminals 1 and 2 of the pressure switch connector on the vehicle wire harness side using a service wire.
Start the engine.
Turn the air conditioning switch on and check that the magnet clutch is turned on.
Check that the magnet clutch is turned off when disconnecting terminals 1 and 2 (that are connected in the prior step).