Home › SUSPENSION & AXLE › SUSPENSION › FRONT SHOCK ABSORBER (for 2WD)

FRONT SHOCK ABSORBER (for 2WD) > INSTALLATION

for Preparation Click here



1. TEMPORARILY TIGHTEN FRONT SHOCK ABSORBER WITH COIL SPRING


F052442E01
  1. LH Side:

    1. Install the coil spring onto the body with the lower end of the coil spring facing the outer side of the vehicle.

  1. RH Side:

    1. Install the coil spring onto the body with the lower end of the coil spring facing the inner side of the vehicle.



    F051504
  1. Install the 3 nuts onto the upper side of the front shock absorber with coil spring.

    Torque:
    64 N*m{ 653 kgf*cm , 47 ft.*lbf }



    F051503
  1. Temporarily tighten the bolt, nut and washer as shown in the illustration.



2. TEMPORARILY TIGHTEN FRONT SUSPENSION UPPER ARM


F051491
  1. Install the front suspension upper arm, and temporarily tighten the 2 bolts.



    F051492
  1. Install a new nut and a new clip.

    Torque:
    110 N*m{ 1122 kgf*cm , 81 ft.*lbf }



3. INSTALL FRONT FLEXIBLE HOSE


F051489
  1. Install the front flexible hose with the bolt.

    Torque:
    32 N*m{ 326 kgf*cm , 24 ft.*lbf }



4. INSTALL SKID CONTROL SENSOR WIRE


F051488
  1. Install the skid control sensor wire with the 2 bolts.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }

  1. Connect the speed sensor connector.



5. INSTALL FRONT WHEEL

Torque:
113 N*m{ 1152 kgf*cm , 83 ft.*lbf }



6. STABILIZE SUSPENSION
  1. Jack down the vehicle.

  1. Bounce the vehicle up and down several times to stabilize the suspension.



7. FULLY TIGHTEN FRONT SHOCK ABSORBER WITH COIL SPRING


F051503
  1. Fully tighten the nut.

    Torque:
    83 N*m{ 846 kgf*cm , 61 ft.*lbf }



8. FULLY TIGHTEN FRONT SUSPENSION UPPER ARM


F051491
  1. Fully tighten the 2 bolts.

    Torque:
    82 N*m{ 836 kgf*cm , 60 ft.*lbf }



9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

(Click here)


10. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
(Click here)