Home › TRANSMISSION ยท A750E AUTOMATIC TRANSMISSION › EXTENSION HOUSING REAR OIL SEAL

EXTENSION HOUSING REAR OIL SEAL > INSTALLATION

for Preparation Click here



1. INSTALL AUTOMATIC TRANSMISSION EXTENSION HOUSING OIL SEAL


C179287E01
  1. Coat the oil seal lip with MP grease.

  1. Using SST and a hammer, carefully tap in a new oil seal until it is flush with the automatic transmission extension housing.

    SST
    09316-60011   (09316-00011, 09316-00051)

    Oil seal tap in depth (A):
    5.4 to 5.8 mm (0.213 to 0.228 in.)



2. INSTALL PROPELLER WITH/CENTER BEARING SHAFT ASSEMBLY


D033911E01
  1. Remove SST from the extension housing.

  1. Install the propeller shaft into the extension housing.



    C060588E01
  1. Align the matchmarks on the propeller shaft flange and differential flange.

  1. Install the propeller shaft with the 4 bolts, 4 nuts and 4 washers.

    Torque:
    88 N*m{ 899 kgf*cm , 65 ft.*lbf }



    D033899E01
  1. Provisionally install the center support bearing with the 2 mounting bolts.

    HINT:
    Make sure the bearing is installed with the drain hole facing downwards.



    F052184E02
  1. Adjust the center support bearing.

    HINT:
    1. With the vehicle unladen, adjust the center support bearing to keep the intervals, as shown.
    2. In the same condition, check the center line in the axial direction. Adjust the bearing if necessary.
    3. The center bearing center line and center bearing housing center line must be adjusted to within -1.0 to 1.0 mm (-0.039 to 0.039 in.) of each other in the vehicle's longitudinal direction when the vehicle is unladen.

  1. Torque the 2 bolts.

    Torque:
    36 N*m{ 369 kgf*cm , 27 ft.*lbf }



3. ADD AUTOMATIC TRANSMISSION FLUID
(Click here)