POWER STEERING SYSTEM > ON-VEHICLE INSPECTION |
| 1. INSPECT DRIVE BELT |
![]() |
Visually check the belt for defects, such as excessive wear and frayed cords.
If any defects are found, replace the drive belt.
| 2. BLEED POWER STEERING SYSTEM |
Check the fluid level.
Jack up the front of the vehicle and support it with stands.
Turn the steering wheel.
With the engine stopped, turn the wheel slowly from lock to lock several times.
Lower the vehicle.
Start the engine.
Run the engine at idle for a few minutes.
Turn the steering wheel.
With the engine idling, turn the wheel to the left or right full lock position and keep it there for 2 to 3 seconds. Then turn the wheel to the opposite full lock position and keep it there for 2 to 3 seconds (step A).
Repeat step A several times.
Stop the engine.
![]() |
Check for foaming or emulsification.
Especially, if the system has to be bled twice because of foaming or emulsification, check for fluid leakage in the system.
Check the fluid level.
| 3. INSPECT FLUID LEVEL |
![]() |
Keep the vehicle level.
With the engine stopped, check the fluid level in the oil reservoir.
If necessary, add fluid.
Start the engine and let it idle.
Turn the steering wheel from lock to lock several times to raise fluid temperature.
![]() |
Check for foaming or emulsification.
If any foaming or emulsification is identified, bleed the power steering system.
![]() |
With the engine idling, measure the fluid level in the oil reservoir.
Stop the engine.
Wait a few minutes and measure the fluid level in the oil reservoir again.
Check the fluid level.
| 4. INSPECT STEERING FLUID PRESSURE |
for 2TR-FE:
Disconnect the pressure feed tube from the vane pump .
for 1GR-FE:
Disconnect the pressure feed tube from the vane pump .
for 2TR-FE:
Connect SST as shown in the illustration.

for 1GR-FE:
Connect SST as shown in the illustration.

Bleed the power steering system.
Start the engine and let it idle.
Turn the steering wheel from lock to lock several times to raise the fluid temperature.
![]() |
With the engine idling, close the valve of SST and check the reading on SST.
![]() |
With the engine idling, fully open the valve.
Measure the fluid pressure at the engine speeds of 1,000 rpm and 3,000 rpm.
![]() |
With the engine idling and valve fully open, turn the steering wheel to the full lock position.
Disconnect SST.
for 2TR-FE:
Connect the pressure feed tube to the vane pump .
for 1GR-FE:
Connect the pressure feed tube to the vane pump .
Bleed the power steering system.
| 5. INSPECT STEERING EFFORT |
![]() |
Center the steering wheel assembly.
Remove the horn button assembly (Click here).
Start the engine and let it idle.
Measure the steering effort in both directions.
Install the steering wheel assembly set nut.
Install the horn button assembly (Click here).