CLUTCH UNIT (for R155) > INSTALLATION |
| 1. INSTALL INPUT SHAFT BEARING |
![]() |
Using SST and a hammer, install the input shaft bearing.
Install 4 new bolts.
![]() |
Mark each bolt with paint as shown in the illustration.
Retighten each bolt by 90°.
Check that the mark on each bolt is at a 90° angle from its original position.
| 2. INSPECT INPUT SHAFT BEARING |
![]() |
Turn the bearing by hand while applying force in the rotation direction.
If the bearing is stuck or difficult to turn, replace the input shaft bearing.
| 3. INSTALL CLUTCH DISC ASSEMBLY |
![]() |
Insert SST into the clutch disc assembly, then insert them into the flywheel sub-assembly.
| 4. INSTALL CLUTCH COVER ASSEMBLY |
![]() |
Align the matchmarks on the clutch cover assembly and flywheel sub-assembly.
Tighten the 6 bolts, in the order shown in the illustration, starting with the bolt located near the knock pin on the top.
| 5. INSPECT AND ADJUST CLUTCH COVER ASSEMBLY |
![]() |
Using a dial indicator with roller instrument, check the diaphragm spring tip alignment.
| 6. INSTALL RELEASE FORK SUPPORT |
Install the release fork support onto the transaxle assembly.
| 7. INSTALL RELEASE BEARING HUB CLIP |
| 8. INSTALL CLUTCH RELEASE FORK SUB-ASSEMBLY |
![]() |
Apply release hub grease to the release fork and release bearing assembly contact surfaces, release fork and push rod contact surface and release fork pivot point.
| *1 | Release hub grease |
Install the release fork onto the release bearing assembly.
| 9. INSTALL CLUTCH RELEASE BEARING ASSEMBLY |
Apply clutch spline grease to the input shaft spline.
Install the bearing onto the release fork, and then install them onto the transaxle assembly.
| 10. INSTALL CLUTCH RELEASE FORK BOOT |
| 11. INSTALL MANUAL TRANSMISSION UNIT ASSEMBLY |