STARTER (for 4WD) > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE NO.1 ENGINE UNDER COVER SUB-ASSEMBLY |
Remove the 4 bolts, then remove the engine under cover.
| 3. REMOVE NO.2 EXHAUST FRONT PIPE ASSEMBLY |
| 4. REMOVE FRONT FENDER SEAL LH |
![]() |
Remove the 5 clips, then remove the front fender splash shield rear LH.
| 5. REMOVE NO.2 STEERING INTERMEDIATE SHAFT |
![]() |
Loosen bolt A and remove bolt B, then separate the steering intermediate shaft No. 2
| 6. REMOVE STARTER ASSEMBLY |
![]() |
Disconnect the terminal 50 connector from the starter assembly.
Remove the nut, then remove the wire harness from terminal 30.
Remove the 2 bolts, then remove the starter assembly.