FRONT DIFFERENTIAL CARRIER ASSEMBLY (for 4WD) > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE FRONT WHEELS |
| 3. REMOVE NO.2 ENGINE UNDER COVER SUB-ASSEMBLY |
Remove the 4 bolts and No. 2 engine under cover sub-assembly.
| 4. REMOVE NO.1 ENGINE UNDER COVER SUB-ASSEMBLY |
Remove the 4 bolts and No. 1 engine under cover sub-assembly.
| 5. DRAIN DIFFERENTIAL OIL |
![]() |
Stop the vehicle on a level place.
Remove the differential filler plug and gasket.
Check that the oil level is within 5 mm (0 to 0.20 in.) of the bottom of the filler plug opening.
Check for oil leakage if the oil level is low.
Install the differential filler plug and a new gasket.
| 6. REMOVE FRONT PROPELLER SHAFT ASSEMBLY |
![]() |
Place matchmarks on the propeller shaft flange and differential flange.
Remove the 4 nuts, 4 bolts, 4 washers and front propeller shaft.
![]() |
Place matchmarks on the propeller shaft flange and transfer flange.
Remove the 4 nuts, 4 washers and front propeller shaft.
| 7. REMOVE FRONT AXLE SHAFT LH NUT |
![]() |
Using a screwdriver and a hammer, remove the front axle hub grease cap.
![]() |
Remove the cotter pin and adjusting cap.
Remove the front axle hub nut.
| 8. REMOVE FRONT AXLE SHAFT RH NUT |
| 9. SEPARATE FRONT STABILIZER LINK ASSEMBLY LH |
![]() |
Remove the 2 nuts and front stabilizer link LH.
| 10. SEPARATE FRONT STABILIZER LINK ASSEMBLY RH |
| 11. SEPARATE FRONT SPEED SENSOR LH |
![]() |
Disconnect the speed sensor connector.
Remove the bolt and front speed sensor.
| 12. SEPARATE FRONT SPEED SENSOR RH |
| 13. SEPARATE TIE ROD END SUB-ASSEMBLY LH |
Remove the cotter pin and nut.
![]() |
Using SST, separate the tie rod end from the steering knuckle arm.
| 14. SEPARATE TIE ROD END SUB-ASSEMBLY RH |
| 15. SEPARATE FRONT SUSPENSION LOWER ARM LH |
![]() |
Remove the 2 bolts and separate the front lower ball joint attachment from the steering knuckle.
| 16. SEPARATE FRONT SUSPENSION LOWER ARM RH |
| 17. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH |
![]() |
Using SST, remove the front drive shaft.
| 18. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH |
| 19. REMOVE FRONT DIFFERENTIAL CARRIER ASSEMBLY |
![]() |
Remove the bolt and separate the front differential breather tube bracket.
Support the front differential with a jack.
Remove the front differential mount nut No. 1.
Remove the 2 front mounting bolts and 2 nuts.
Disconnect the actuator hose and connector.
Lower the jack and remove the front differential assembly.
Remove the 2 bolts and No. 3 front differential support.
Remove the 5 bolts and 2 front differential supports.