Home › ENGINE ยท 1GR-FE › ENGINE MECHANICAL › REAR CRANKSHAFT OIL SEAL

REAR CRANKSHAFT OIL SEAL > INSTALLATION

for Preparation Click here



1. INSTALL REAR ENGINE OIL SEAL


A076329E01
  1. Apply MP grease to a new oil seal tip.

  1. Using SST and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.

    SST
    09223-78010  



2. INSTALL FLYWHEEL SUB-ASSEMBLY (for Manual Transmission)


A076326E01
  1. Using SST, hold the crankshaft.

    SST
    09213-54015   (91651-60855)
    09330-00021  



    P000601E02
  1. Apply adhesive to 2 or 3 threads of the mounting bolt end.

    Adhesive:
    Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent



    G036171E01
  1. Install the flywheel and 2 spacers onto the crankshaft.

  1. Using several steps, uniformly install and tighten the 8 mounting bolts in the sequence shown in the illustration.

    Torque:
    83 N*m{ 846 kgf*cm , 61 ft.*lbf }



3. INSTALL DRIVE PLATE & RING GEAR SUB-ASSEMBLY (for Automatic Transmission)


A076326E03
  1. Using SST, hold the crankshaft.

    SST
    09213-54015   (91651-60855)
    09330-00021  



    P000601E02
  1. Apply adhesive to 2 or 3 threads of the mounting bolt end.

    Adhesive:
    Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent



    A076327E02
  1. Install the drive plate and 2 spacers onto the crankshaft.

  1. Using several steps, uniformly install and tighten the 8 mounting bolts in the sequence shown in the illustration.

    Torque:
    83 N*m{ 846 kgf*cm , 61 ft.*lbf }



4. INSTALL TRANSMISSION ASSEMBLY

HINT:
Refer to the table below when installing transmission.

Transmission
Drive Type
See page
Manual Transmission
2WD
Click here
Manual Transmission
4WD
Click here
Automatic Transmission
2WD
Click here
Automatic Transmission
4WD
Click here