Home › ENGINE ยท 1GR-FE › ENGINE MECHANICAL › REAR CRANKSHAFT OIL SEAL

REAR CRANKSHAFT OIL SEAL > REMOVAL

for Preparation Click here



1. REMOVE TRANSMISSION ASSEMBLY

HINT:
Refer to the table below when removing transmission.

Transmission
Drive Type
See page
Manual Transmission
2WD
Click here
Manual Transmission
4WD
Click here
Automatic Transmission
2WD
Click here
Automatic Transmission
4WD
Click here



2. REMOVE FLYWHEEL SUB-ASSEMBLY (for Manual Transmission)


A076326E01
  1. Using SST, hold the crankshaft.

    SST
    09213-54015   (91651-60855)
    09330-00021  



    G036171E02
  1. Remove the 8 bolts, then remove the flywheel and 2 spacers.



3. REMOVE DRIVE PLATE & RING GEAR SUB-ASSEMBLY (for Automatic Transmission)


A076326E03
  1. Using SST, hold the crankshaft.

    SST
    09213-54015   (91651-60855)
    09330-00021  



    A076327E01
  1. Remove the 8 bolts, then remove the drive plate and 2 spacers.



4. REMOVE REAR ENGINE OIL SEAL


A076328E01
  1. Using a knife, cut off the oil seal lip.

  1. Using a screwdriver, pry out the oil seal.

    NOTICE:
    Be careful not to damage the crankshaft. Wrap the screwdriver tip with tape.