DTC P0722 Output Speed Sensor Circuit No Signal |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0722 |
|
|

| Terminal | SP2+ - SP2- |
| Tool setting | 2 V/DIV, 20 msec./DIV |
| Vehicle condition | Vehicle speed 20 km/h (12 mph) |
| Related DTCs | P0722 : speed sensor (SP2)/Verify pulse input |
| Required Sensors/Components | Speed sensor (SP2) |
| Frequency of operation | Continuous |
| Duration | 5 seconds |
| MIL operation | 2 driving cycles |
| Sequence of operation | None |
| The monitor will run whenever this DTC is not present. | None |
| Vehicle speed at vehicle speed sensor | 9 km/h (5.6 mph) or more |
| Output speed sensor pulse signal | No signal |
| Vehicle speed at output speed sensor | 9 km/h (5.6 mph) or more |

| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| SPD (SP2) | Output shaft speed/ Min.: 0 km/h (0 mph) Max.: 255 km/h (158 mph) | Vehicle stopped: 0 km/h (0 mph) (output shaft speed is equal to vehicle speed) | - |
| 1.INSPECT SPEED SENSOR (SP2) INSTALLATION |
![]() |
Check the speed sensor (SP2) installation.
|
| ||||
| OK | |
| 2.INSPECT SPEED SENSOR (SP2) |
![]() |
Disconnect the speed sensor (SP2) connector from the transmission.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | 20°C (68°F) | 560 to 680 Ω |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (SPEED SENSOR (SP2) - ECM) |
![]() |
Connect the speed sensor (SP2) connector.
Disconnect the connector from the ECM.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E11-9 (SP2+) - E11-10 (SP2-) | 20°C (68°F) | 560 to 680 Ω |
| E11-9 (SP2+) - Body ground | Always | 10 kΩ or higher |
| E11-10 (SP2-) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||