CAN COMMUNICATION SYSTEM > Center Airbag Sensor Communication Stop Mode |
| Detection Item | Symptom | Trouble Area |
| Center Airbag Sensor Communication Stop Mode |
|
|

| 1.PRECAUTION |
| NEXT | |
| 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the main wire and the branch wire.
| NEXT | |
| 3.CHECK FOR OPEN IN CAN BUS WIRE (CENTER AIRBAG SENSOR ASSEMBLY BRANCH WIRE) |
Turn the ignition switch off.
![]() |
Disconnect the A21 center airbag sensor assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A21-13 (CANH) - A21-22 (CANL) | Ignition switch off | 54 to 69 Ω |
| *a | Front view of wire harness connector (to Center Airbag Sensor Assembly) |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (CENTER AIRBAG SENSOR ASSEMBLY - BATTERY AND BODY GROUND) |
Connect the cable to the negative (-) battery terminal.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A21-25 (E1) - Body ground | Always | Below 1 Ω |
| A21-26 (E2) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector (to Center Airbag Sensor Assembly) |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A21-21 (IG2) - Body ground | Ignition switch ON | 11 to 14 V |
|
| ||||
| OK | ||
| ||