DTC P0711 Transmission Fluid Temperature Sensor "A" Performance |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0711 | Any of the following conditions (A), (B) or (C) is met: |
|
| Condition (A): (a), (b), (c) and (d) are detected: (2-trip detection logic)
| ||
| Condition (B): (a), (b)and (c) are detected: (2-trip detection logic)
| ||
| Condition (C): Both (a) and (b) are detected: (2-trip detection logic)
|
| Related DTCs | P0711: ATF temperature sensor/Rationality check |
| Required sensors/Components | No. 1 ATF temperature sensor |
| Frequency of operation | Continuous |
| Duration | 3 seconds |
| MIL operation | 2 driving cycles |
| Sequence of operation | None |
| The monitor will run whenever the following DTCs are not present | P0712, P0713, P2742, P2743 (ATF temperature sensor "A" circuit) P0128 (ECT (Engine Coolant Temperature) sensor circuit) P0111, P011B, P0112, P0113 (IAT (Intake Air Temperature) sensor circuit) |
| Time after engine start | 10 minutes or more |
| Driving distance after engine start | 4.9 km (3.0 miles) or more |
| IAT (12 seconds after engine start) | 15°C (59°F) or more |
| ECT (12 seconds after engine start) | 15°C (59°F) or more |
| Soak time | 5 hours or more |
| Time after engine start | 21 minutes and 40 seconds or more |
| Driving distance after engine start | 9 km (5.6 miles) or more |
| IAT (12 seconds after engine start) | -10°C (14°F) or more |
| ECT (12 seconds after engine start) | -10°C (14°F) or more |
| ECT | 60°C (140°F) or more |
| ECT (12 seconds after engine start) | Less than 35°C (95°F) |
| ATF temperature | Less than 20°C (68°F) |
| ATF temperature | 110°C (230°F) or more |
| ATF temperature | 20 to 110°C (68 to 230°F) |

| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| A/T Oil Temperature 1 | No. 1 ATF temperature sensor value/ Min.: -40°C (-40°F) Max.: 215°C (419°F) |
| If value is -40°C (-40°F) or 215°C (419°F), No. 1 ATF temperature sensor circuit is open or short circuited |
| Temperature Displayed | Malfunction |
| -40°C (-40°F) | Open circuit |
| 150°C (302°F) or more | Short circuit |
| 1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0711) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read the DTCs using the Techstream.
| Result | Proceed to |
| Only P0711 is output | A |
| P0711 and other DTCs are output | B |
|
| ||||
| A | |
| 2.CHECK TRANSMISSION FLUID LEVEL |
Check the transmission fluid level (Click here).
|
| ||||
| OK | ||
| ||