Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

DTC    B15FE    XM Tuner Antenna Disconnected

DTC    B15FF    XM Tuner Antenna Short

for Preparation Click here


DESCRIPTION

These DTCs are stored when a malfunction occurs in the roof antenna assembly which is connected to the radio and display receiver assembly.

DTC No.
DTC Detection Condition
Trouble Area
B15FE
The roof antenna assembly is not connected.
  1. Antenna cord sub-assembly
  2. Harness or connector
  3. Roof antenna assembly
  4. Radio and display receiver assembly
B15FF
A short occurs in the roof antenna assembly.

INSPECTION PROCEDURE

NOTICE:
After replacing the radio and display receiver assembly of vehicles subscribed to pay-type satellite radio broadcasts, XM radio ID registration is necessary.

1.REPLACE ANTENNA CORD SUB-ASSEMBLY
  1. Replace the antenna cord sub-assembly with a known good one and check if the same DTC is output again (Click here).

    1. Clear the DTCs (Click here).

    2. Recheck for DTCs and check if the same DTC is output again.

      OK:
      No DTCs are output.



NG
Go to step 2
OK

END 

2.CHECK HARNESS AND CONNECTOR (SATELLITE RADIO ANTENNA CORD)
  1. Disconnect the satellite radio antenna cord.

  1. Measure the resistance of the satellite radio antenna cord to check for an open circuit in the satellite radio antenna cord.

    Standard Resistance:
    Below 1 Ω

  1. Measure the resistance between the satellite radio antenna cord and body ground to check for a short circuit in the satellite radio antenna cord.

    Standard Resistance:
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.REPLACE ROOF ANTENNA ASSEMBLY
  1. Replace the roof antenna assembly with a known good one and check if the same DTC is output again (Click here).

    1. Clear the DTCs (Click here).

    2. Recheck for DTCs and check if the same DTC is output again.

      OK:
      No DTCs are output.



NG
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY (Click here)
OK

END