Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Microphone Circuit between Microphone and Radio Receiver

for Preparation Click here


DESCRIPTION

This circuit sends the voice signal from the telephone microphone assembly to the radio receiver assembly.
It also supplies power from the radio receiver assembly to the telephone microphone assembly.

WIRING DIAGRAM


E232754E03


INSPECTION PROCEDURE

NOTICE:
After replacing the radio receiver assembly of vehicles subscribed to pay-type satellite radio broadcasts, XM radio ID registration is necessary (w/ SDARS System).

1.INSPECT RADIO RECEIVER ASSEMBLY


    E232755E01
  1. Disconnect the R10 radio receiver assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    R10-3 (MACC) - Body ground
    Ignition switch ACC
    4 to 6 V

    Text in Illustration 
    *a
    Component without harness connected
    (Radio Receiver Assembly)



NG
REPLACE RADIO RECEIVER ASSEMBLY (Click here)
OK


2.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - TELEPHONE MICROPHONE ASSEMBLY)
  1. Disconnect the R10 radio receiver assembly connector.

  1. Disconnect the T21 telephone microphone assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    R10-1 (SNS2) - T21-3 (SNS2)
    Always
    Below 1 Ω
    R10-2 (MIC+) - T21-2 (MCO+)
    Always
    Below 1 Ω
    R10-5 (MIC-) - T21-4 (MCO-)
    Always
    Below 1 Ω
    R10-3 (MACC) - T21-1 (MACC)
    Always
    Below 1 Ω
    R10-1 (SNS2) - Body ground
    Always
    10 kΩ or higher
    R10-2 (MIC+) - Body ground
    Always
    10 kΩ or higher
    R10-5 (MIC-) - Body ground
    Always
    10 kΩ or higher
    R10-3 (MACC) - Body ground
    Always
    10 kΩ or higher
    R10-6 (SGND) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE TELEPHONE MICROPHONE ASSEMBLY (Click here)