Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Mute Signal Circuit between Radio Receiver and Multi-media Interface ECU

for Preparation Click here


DESCRIPTION

The multi-media interface ECU sends a mute signal to the radio receiver assembly.
The radio receiver assembly controls the volume according to the mute signal from the multi-media interface ECU.
The mute signal is sent to reduce noise and popping sounds generated when switching modes.
If there is an open in the circuit, noise can be heard from the speakers when changing the sound source.
If there is a short in the circuit, even though the radio receiver assembly is functioning, no sound, or only an extremely faint sound, can be heard.

WIRING DIAGRAM


E226280E01


INSPECTION PROCEDURE

NOTICE:
After replacing the radio receiver assembly of vehicles subscribed to pay-type satellite radio broadcasts, XM radio ID registration is necessary (w/ SDARS System).

1.INSPECT MULTI-MEDIA INTERFACE ECU


    E232751E01
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    M4-6 (MUT1) - Body ground
    Ignition switch ACC
    Above 3.5 V

    Text in Illustration 
    *a
    Component with harness connected
    (Multi-media Interface ECU)



NG
Go to step 2
OK

REPLACE MULTI-MEDIA INTERFACE ECU (Click here)  

2.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - MULTI-MEDIA INTERFACE ECU)
  1. Disconnect the R14 radio receiver assembly connector.

  1. Disconnect the M4 multi-media interface ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    R14-6 (MUTE) - M4-6 (MUT1)
    Always
    Below 1 Ω
    R14-6 (MUTE) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE RADIO RECEIVER ASSEMBLY (Click here)