DTC P2109 Throttle / Pedal Position Sensor "A" Minimum Stop Performance |
| DTC No. | DTC Detection Condition | Trouble Area |
| P2109 | The ISC learned value is approximately 3 times larger than normal even though the actual intake air amount during idling is within the normal range (up to 1.5 times the normal amount) (5 trip detection logic). | Throttle with motor body assembly |
| 1.CHECK FOR ANY OTHER DTCS OUTPUT (IN ADDITION TO P2109) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read DTCs.
| Result | Proceed to |
| DTC P2109 is output | A |
| DTC P2109 and other DTCs are output | B |
|
| ||||
| A | |
| 2.CHECK FREEZE FRAME DATA |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Using the Techstream, check "ISC Learning Value" in the freeze frame data (Click here).
| NEXT | |
| 3.REMOVE FOREIGN OBJECT (CLEAN THROTTLE WITH MOTOR BODY ASSEMBLY) |
![]() |
Clean off any deposits from the inside of the throttle with motor body assembly.
| *1 | Bore |
| *2 | Valve |
| *a | Reference |
| *b | Throttle with Motor Body Assembly Cross-section Diagram |
| *c | When valve fully opened |
| *d | Deposits |
| *e | Do not directly apply cleaner |
Push open the throttle valve and wipe off any carbon from the valve and bore using a cloth soaked in non-residue solvent.
| NEXT | |
| 4.READ VALUE USING TECHSTREAM (ISC LEARNING VALUE) |
Remove the EFI and ETCS fuses at the same time, wait 60 seconds or more, and then reinstall the fuses to reset the ISC learned value.
Connect the Techstream to the DLC3.
Start the engine and fully warm it up.
Turn the Techstream on.
Leave the vehicle idling for 3 minutes or more and check that the engine speed is at the standard idling speed.
Enter the following menus: Powertrain / Engine and ECT / Data List / ISC Learning Value.
Read the value.
|
| ||||
| OK | ||
| ||