Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

DTC    C0226/21    SFR Solenoid Circuit

DTC    C0236/22    SFL Solenoid Circuit

DTC    C0246/23    SRR Solenoid Circuit

DTC    C0256/24    SRL Solenoid Circuit

DTC    C1225/25    SMC Solenoid Circuit

DTC    C1226/26    SMC Solenoid Circuit

DTC    C1227/27    SRC Solenoid Circuit

DTC    C1228/28    SRC Solenoid Circuit

for Preparation Click here


DESCRIPTION

This solenoid is turned on in accordance with signals from the skid control ECU and controls the pressure on the wheel cylinders to control the braking force.

C160048E01


DTC Code
DTC Detection Condition
Trouble Area
C0226/21
C0236/22
C0246/23
C0256/24
Open or short in solenoid circuit continues for 0.05 seconds or more.
Skid control ECU
C1225/25
C1226/26
C122727
C1228/28
When any of following conditions detected:
  1. During switching solenoid (SMC1, SMC2, SRC1 or SRC2) ON signal input, overcurrent continues for 0.05 seconds or more.
  2. During switching solenoid (SMC1, SMC2, SRC1 or SRC2) OFF signal input, open circuit continues for 0.05 seconds or more.
  3. During switching solenoid (SMC1, SMC2, SRC1 or SRC2) ON signal input, open circuit continues for 0.01 seconds or more.
  4. During switching solenoid (SMC1, SMC2, SRC1 or SRC2) OFF signal input, current continues to be applied for 0.1 seconds or more.
  5. Short to GND in switching solenoid (SMC1, SMC2, SRC1 or SRC2) continues for 0.1 seconds or more.
  6. Switching solenoids (SMC1, SMC2, SRC1 or SRC2) shorted for 0.1 seconds or more.
Skid control ECU

INSPECTION PROCEDURE

NOTICE:
When replacing the VSC actuator assembly, perform zero point calibration (Click here).

1.RECONFIRM DTC
  1. Clear the DTC(s) (Click here).

  1. Start the engine.

  1. Check if the same DTC(s) is output (Click here).
    Result 
    Result
    Proceed to
    DTC is output
    A
    DTC is not output
    B

    HINT:
    The DTCs may be stored due to a malfunction in the connector terminal.



B
USE SIMULATION METHOD TO CHECK (Click here)
A

REPLACE VSC ACTUATOR ASSEMBLY (Click here)