Home › BRAKE › BRAKE CONTROL › BRAKE ACTUATOR

BRAKE ACTUATOR > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
  1. After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.
  2. Some systems need to be initialized after the cable is reconnected (Click here).



2. DISCONNECT VSC ACTUATOR CONNECTOR


    C154434
  1. Pull the release bar and disconnect the VSC actuator connector.



3. REMOVE BRAKE TUBE


    C154437E02
  1. Use tags or make a note to identify the reconnection locations.



    C155454E03
  1. Using a union nut wrench, disconnect the 2 brake tubes from the VSC actuator.



    C155449E04
  1. Using a union nut wrench, remove the 2 brake tubes from the brake master cylinder.



4. DISCONNECT BRAKE TUBE


    C155455E03
  1. Using a union nut wrench, disconnect the 4 brake tubes from the VSC actuator.



5. REMOVE VSC ACTUATOR WITH ACTUATOR BRACKET ASSEMBLY


    C155484
  1. Remove the 3 nuts and VSC actuator with actuator bracket.