DTC P0010 Camshaft Position "A" Actuator Circuit (Bank 1) |
DTC P0020 Camshaft Position "A" Actuator Circuit (Bank 2) |

| DTC Code | DTC Detection Condition | Trouble Area |
| P0010 | Open or short in OCV (bank 1) circuit (1 trip detection logic) |
|
| P0020 | Open or short in OCV (bank 2) circuit (1 trip detection logic) |
|
| Related DTCs | P0010: VVT OCV range check (bank 1) P0020: VVT OCV range check (bank 2) |
| Required Sensors/Components (Main) | VVT OCV |
| Required Sensors/Components (Related) | - |
| Frequency of Operation | Continuous |
| Duration | 1 second |
| MIL Operation | Immediate |
| Sequence of Operation | None |
| Monitor runs whenever following DTCs not present | None |
| All of following conditions met | - |
| Starter | OFF |
| Ignition switch | ON |
| Time after ignition switch OFF to ON | 0.5 seconds or more |
| VVT Oil Control Valve condition | No operation record |
| VVT OCV duty ratio | 3 to 100% |

| 1.CHECK DTC |
Clear DTC after recording the freeze frame data and DTC.
Turn the ignition switch OFF.
Allow the engine to idle and check DTC.
Check that P0010 or P0020 is present.
|
| ||||
| OK | |
| 2.INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY |
![]() |
Disconnect the D42 or D43 OCV connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | 20°C (68°F) | 6.9 to 7.9 Ω |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (OCV - ECM) |
![]() |
Disconnect the D42 or D43 OCV connector.
Disconnect the D74 ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D42-1 - D74-58 (OC1+) | Always | Below 1 Ω |
| D43-1 - D74-52 (OC2+) | Always | Below 1 Ω |
| D42-2 - D74-57 (OC1-) | Always | Below 1 Ω |
| D43-2 - D74-51 (OC2-) | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| D42-1 or D74-58 (OC1+) - Body ground | Always | 10 kΩ or higher |
| D43-1 or D74-52 (OC2+) - Body ground | Always | 10 kΩ or higher |
| D42-2 or D74-57 (OC1-) - Body ground | Always | 10 kΩ or higher |
| D43-2 or D74-51 (OC2-) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||