Home › ENGINE ยท 1GR-FE › ENGINE CONTROL SYSTEM › ECM

ECM > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
  1. Some systems need to be initialized after the cable is reconnected (Click here).
  2. After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.



2. DISCONNECT CONNECTOR HOLDER BLOCK


    A155992
  1. Remove the 3 bolts and move the connector holder block so that the ECM can be removed in the next step.



3. REMOVE ECM


    A124571E01
  1. Raise the 2 levers while pushing the locks on the 2 levers.

    NOTICE:
    A155994
    Make sure that the lock lever is raised 90° as shown in the illustration before disconnecting the ECM connectors. Failure to do this may cause the ECM connectors to break.

  1. Disconnect the 2 connectors.



    A155993
  1. Remove the 4 bolts and ECM.



4. REMOVE ECM GASKET


A167150
  1. Peel off the rubber part of the gasket.



    A167151
  1. Spray gasket remover or equivalent on the remaining tape of the gasket.

    NOTICE:
    When using gasket remover or equivalent, cover the ECM connector with a cloth.



    A167152
  1. Use a cutter knife to remove the tape of the gasket.

    NOTICE:
    Do not damage the ECM seal's surface with the knife.