DTC P0101 Mass Air Flow Circuit Range / Performance Problem |
| DTC Code | DTC Detection Condition | Trouble Area |
| P0101 | Conditions (a), (b), (c), (d) and (e) continue for more than 10 seconds (2 trip detection logic): (a) Engine running (b) Engine coolant temperature 70°C (158°F) or higher (c) Throttle Position (TP) sensor voltage 0.2 to 2 V (d) Average engine load value ratio less than 0.85, or more than 1.17 (varies with estimated engine load) Average engine load value ratio = Average engine load based on MAF meter output / Average engine load estimated from driving conditions (e) Average air-fuel ratio less than -15%, or more than 15% |
|
| Related DTCs | P0101: Mass air flow meter rationality |
| Required Sensors/Components (Main) | Mass air flow meter |
| Required Sensors/Components (Related) | Crankshaft Position (CKP) sensor, Engine Coolant Temperature (ECT) sensor and Throttle Position (TP) sensor |
| Frequency of Operation | Continuous |
| Duration | 10 seconds |
| MIL Operation | 2 driving cycles |
| Sequence of Operation | None |
| Monitor runs whenever following DTCs not present | P0110, P0112, P0113 (Intake Air Temperature Sensor) P0115, P0117, P0118 (Engine Coolant Temperature Sensor) P0335 (Crankshaft Position Sensor) P0120, P0121, P0122, P0123, P0220, P0222, P0223, P2135 (Throttle Position Sensor) P0452, P0453 (EVAP System) P2401, P2402 (Leak Detection Pump) P2419, P2420 (Vent Valve) |
| Throttle position (TP sensor voltage) | 0.2 to 3.6 V |
| Time after engine starts | 5 seconds |
| Battery voltage | 10.5 V or more |
| Estimated Load | 30 to 100 |
| Engine coolant temperature | 70°C (158°F) or more |
| Both of following conditions 1 and 2 met | - |
| 1. Averaged engine load value ratio | Less than 0.85, or more than 1.17 (varies with estimated engine load) |
| 2. Averaged air-fuel ratio | Less than -15%, or more than 15% |

| 1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0101) |
Connect the Techstream to the DLC3.
Turn the ignition switch ON.
Turn the Techstream ON.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read the DTCs.
| Display (DTC Output) | Proceed to |
| P0101 | A |
| P0101 and other DTCs | B |
|
| ||||
| A | |
| 2.CHECK AIR INDUCTION SYSTEM |
Check the air induction system for vacuum leakage .
|
| ||||
| OK | |
| 3.CHECK PCV HOSE CONNECTIONS |
|
| ||||
| OK | ||
| ||