Home › ENGINE ยท 1GR-FE › ENGINE CONTROL SYSTEM › MASS AIR FLOW METER

MASS AIR FLOW METER > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
  1. Some systems need to be initialized after the cable is reconnected (Click here).
  2. After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.



2. REMOVE V-BANK COVER


    A112983E03
  1. Remove the 2 nuts and V-bank cover.



3. REMOVE MASS AIR FLOW METER


    A111698
  1. Disconnect the MAF meter connector.

  1. Remove the 2 screws and MAF meter.