DTC P2118 Throttle Actuator Control Motor Current Range / Performance |

| DTC Code | DTC Detection Condition | Trouble Area |
| P2118 | Open in ETCS power source (+BM) circuit (1 trip detection logic) |
|
| Related DTCs | P2118: Throttle actuator power supply |
| Required Sensors/Components (Main) | Throttle actuator, throttle valve, ETCS fuse |
| Required Sensors/Components (Related) | None |
| Frequency of Operation | Continuous |
| Duration | 0.8 seconds |
| MIL Operation | Immediate |
| Sequence of Operation | None |
| Monitor runs whenever following DTCs not present | None |
| Battery voltage | 8 V or more |
| Electronic throttle actuator power | ON |
| Throttle actuator power supply voltage (+BM) | Less than 4 V |
| Throttle actuator power supply voltage (+BM) | 11 to 14 V |

| 1.READ VALUE USING TECHSTREAM (+BM VOLTAGE) |
Connect the Techstream to the DLC3.
Turn the ignition switch ON.
Turn the Techstream ON.
Enter the following menus: Powertrain / Engine and ECT / Data List / All Data / +BM Voltage.
Read the value displayed on the Techstream.
|
| ||||
| OK | |
| 2.INSPECT BATTERY |
Check that the battery is not depleted.
|
| ||||
| OK | |
| 3.CHECK BATTERY TERMINAL |
Check that the battery terminals and ECM ground are not loose or corroded.
|
| ||||
| OK | ||
| ||
| 4.CHECK FUSE (ETCS) |
![]() |
Remove the ETCS fuse from the engine room relay block, junction block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| ETCS fuse | Always | Below 1 Ω |
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (ECM - ETCS FUSE, ETCS FUSE - BATTERY) |
![]() |
Check the harness and connector between the ETCS fuse and ECM.
Remove the ETCS fuse from the engine room relay block, junction block.
Disconnect the D74 ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| ETCS fuse (2) - D74-41 (+BM) | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| ETCS fuse (2) or D74-41 (+BM) - Body ground | Always | 10 kΩ or higher |
Check the harness and connector between the ETCS fuse and positive (+) battery terminal.
Remove the ETCS fuse from the engine room relay block, junction block.
Disconnect the cable from the positive (+) battery terminal.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| Positive battery cable - ETCS fuse (1) | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| Positive battery cable or ETCS fuse (1) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 6.INSPECT ECM (+BM VOLTAGE) |
![]() |
Disconnect the D74 ECM connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D74-41 (+BM) - D74-81 (E1) | Always | 11 to 14 V |
|
| ||||
| OK | ||
| ||