CAMSHAFT OIL CONTROL VALVE > INSTALLATION |
| 1. INSTALL CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (for Bank 1) |
![]() |
Apply a light coat of engine oil to a new O-ring of the oil control valve.
![]() |
Install the oil control valve with the bolt.
Connect the camshaft timing oil control valve connector.
| 2. INSTALL CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (for Bank 2) |
![]() |
Apply a light coat of engine oil to a new O-ring of the oil control valve.
![]() |
Install the oil control valve with the bolt.
Connect the oil control valve connector.
| 3. INSTALL THROTTLE BODY WITH MOTOR ASSEMBLY |
![]() |
Install a new gasket and the throttle body with motor with the 4 bolts.
Connect the throttle position sensor and throttle control motor connector.
![]() |
Connect the No. 4 water by-pass hose.
![]() |
Connect the No. 5 water by-pass hose.
| 4. INSTALL AIR CLEANER ASSEMBLY WITH ELEMENT |
![]() |
Install the air cleaner with element with the 2 bolts.
Tighten the hose clamp.
![]() |
Connect the MAF meter connector.
Attach the 2 wire harness clamps.
Connect the vacuum hose.
![]() |
Attach the hose clamp.
Connect the No. 2 ventilation hose.
| 5. INSTALL NO. 2 AIR CLEANER HOSE |
![]() |
![]() |
Install the air cleaner hose with the 2 bolts.
Tighten the hose clamp.
| 6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 7. ADD ENGINE COOLANT |
Add engine coolant.
![]() |
Slowly pour coolant into the radiator reservoir until it reaches the FULL line.
Install the reservoir cap.
Press the inlet and outlet radiator hoses several times by hand, and then check the coolant level. If the coolant level is low, add coolant.
Install the radiator cap.
Start the engine and warm it up until the thermostat opens.
Maintain the engine speed at 2000 to 2500 rpm.
Press the inlet and outlet radiator hoses several times by hand to bleed air.
Stop the engine, and wait until the engine coolant cools down to ambient temperature.
![]() |
Check that the coolant level is between the FULL and LOW lines.
If the coolant level is below the LOW line, repeat all of the procedures above.
If the coolant level is above the FULL line, drain coolant so that the coolant level is between the FULL and LOW lines.
| 8. INSPECT FOR ENGINE COOLANT LEAK |
![]() |
Fill the radiator with coolant and attach a radiator cap tester.
Warm up the engine.
Using the radiator cap tester, increase the pressure inside the radiator to 118 kPa (1.2 kgf/cm2, 17 psi), and check that the pressure does not drop.
If the pressure drops, check the hoses, radiator and water pump for leaks. If no external leaks are found, check the heater core, cylinder block and head.
| 9. INSTALL V-BANK COVER |
![]() |
Install the V-bank cover with the 2 nuts.
| 10. INSTALL FRONT COWL TOP OUTER PANEL SUB-ASSEMBLY |
Install the front cowl top outer panel with the 7 bolts.

Connect the 2 washer hoses.
| 11. INSTALL FRONT WIPER MOTOR AND LINK ASSEMBLY |
Install the front wiper motor and link assembly (Click here).
| 12. INSTALL NO. 1 ENGINE UNDER COVER |
Install the engine under cover with the 5 bolts and 3 screws.