THROTTLE BODY > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE NO. 1 ENGINE UNDER COVER |
Remove the 5 bolts, 3 screws and engine under cover.
| 3. DRAIN ENGINE COOLANT |
Loosen the radiator drain cock plug and 2 cylinder block drain cock plugs.
Remove the radiator cap. Then drain the coolant.
Tighten the 2 cylinder block drain cock plugs.

Tighten the radiator drain cock plug by hand.
| 4. REMOVE FRONT WIPER MOTOR AND LINK ASSEMBLY |
Remove the front wiper motor and link assembly (Click here).
| 5. REMOVE FRONT COWL TOP OUTER PANEL SUB-ASSEMBLY |
Disconnect the 2 washer hoses.
Remove the 7 bolts and front cowl top outer panel.

| 6. REMOVE V-BANK COVER |
![]() |
Remove the 2 nuts and V-bank cover.
| 7. REMOVE NO. 2 AIR CLEANER HOSE |
![]() |
Loosen the hose clamp.
Remove the 2 bolts and air cleaner hose.
| 8. REMOVE AIR CLEANER ASSEMBLY WITH ELEMENT |
![]() |
Disconnect the No. 2 ventilation hose.
Detach the hose clamp.
![]() |
Disconnect the vacuum hose.
Disconnect the MAF meter connector.
Using a clip remover, detach the 2 wire harness clamps.
![]() |
Loosen the hose clamp.
Remove the 2 bolts and air cleaner with element.
| 9. REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY |
![]() |
Disconnect the No. 5 water by-pass hose.
![]() |
Disconnect the No. 4 water by-pass hose.
![]() |
Disconnect the throttle position sensor and throttle control motor connector.
Remove the 4 bolts, then remove the throttle body with motor and gasket.