Home › BRAKE › BRAKE CONTROL › YAW RATE AND DECELERATION SENSOR

YAW RATE AND DECELERATION SENSOR > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
  1. After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.
  2. Some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE CENTER FRONT SEAT ASSEMBLY (for Center Seat)


    B165562
  1. Open the center seat cushion.



    B165563
  1. Take out the center seat cushion carpet.



    B165564
  1. Remove the 4 bolts and disconnect the connector.

  1. Remove the center front seat.

    NOTICE:
    Be careful not to damage the vehicle body.



3. REMOVE CONSOLE BOX ASSEMBLY (for Separate Seat Type)
  1. Remove the console box .



4. REMOVE YAW RATE SENSOR
  1. Remove the 2 nuts (labeled A) and sensor.



  1. Disconnect the sensor connector (labeled B), and then detach the clamp (labeled C) from the sensor bracket.


    C154452E01